1. NETLAB+
  2. Cisco
  3. CCNA
  4. Enterprise Networking, Security, and Automation
  5. v7


CCNA3: Enterprise Networking, Security, and Automation v7

All NETLAB+ supported labs in the CCNA3: Enterprise Networking, Security, and Automation v7 course are supported by the Multi-Device Pod (MDP), Multi-Purpose Academy Pod (MAP), and Multi-Purpose Academy Pod with ASA (MAP w/ASA). NETLAB+ VE 19.5.0 or greater is required.

Supported Labs

Lab Number Title Pod Required
2.7.2 Single-Area OSPFv3 Configuration MDP, MAP, or MAP w/ASA
3.8.8 Explore DNS Traffic MDP, MAP, or MAP w/ASA
5.5.2 Configure and Verify Extended ACLs MDP, MAP, or MAP w/ASA
6.8.2 Configure NAT and IPv4 MDP, MAP, or MAP w/ASA
10.6.11 Use Tera Term to Manage Router Configuration Files MDP, MAP, or MAP w/ASA
10.6.12 Use TFTP, Flash, and USB to Manage Configuration Files MDP, MAP, or MAP w/ASA
10.6.13 Research Password Recovery Procedures MDP, MAP, or MAP w/ASA
10.8.2 Configure CDP, LLDP, and NTP MDP, MAP, or MAP w/ASA
13.6.1 Install Linux in a Virtual Machine and Explore the GUI MDP, MAP, or MAP w/ASA
ENSA Skills Assessment MDP, MAP, or MAP w/ASA
Enabling the Labs

To enable the CCNA3: Enterprise Networking, Security, and Automation v7 labs, install the CCNA3: Enterprise Networking, Security, and Automation v7 course using the Course Manager. See the Course Manager section of the NETLAB+ VE Admin Guide for details. The course content will then be available to be added to classes.

MDP MAP MAP w/ASA
Using the Labs

Always select the correct lab exercise for the lab being performed. Students or teams should schedule the correct lab exercise from the catalog. NETLAB+ will only show those labs for which the required pod type is available. A lab that works on different pod types may appear more than once if your system is so equipped. Instructors should select the correct lab from the Exercise tab during instructor-led lab reservations. This can be done as many times as needed during the reservation.

Importance of Choosing the Correct Lab Exercise

Several of the labs may differ from the standard pod topologies. This is handled by NETLAB+ Dynamic VLAN Mapping technology. Always select the correct lab exercise for the actual lab. This insures that NETLAB+ will set up VLANs on the control switch such that lab devices and PCs are placed in the correct LAN segment for the exercise being performed. Selecting the correct exercise will also make the completed lab output easier to find in the archive.